Chrysler 2007 Aspen User Manual download pdf (Page 165)

100

101

NOTE: If programming a garage door opener or gate

operator, it is advised to unplug the device during the

⬙cycling⬙ process to prevent possible overheating.

Using HomeLink

To operate, simply press and release the programmed

HomeLink button. Activation will now occur for the

trained device (i.e. garage door opener, gate operator,

security system, entry door lock, home/office lighting,

etc.). For convenience, the hand-held transmitter of the

device may also be used at any time. In the event that

there are still programming difficulties or questions, con-

tact HomeLink at: www.homelink.com or 1-800-355-3515

Erasing HomeLink Buttons

To erase programming from the three buttons (individual

buttons cannot be erased but can be ⬙reprogrammed⬙ -

note below), follow the step noted:

•

Press and hold the two outer HomeLink buttons, and

the EVIC will display “CLEARING CHANNELS”, do

not release the buttons until “CHANNELS

CLEARED” is displayed on the EVIC (after approxi-

mately 20 seconds). Release both buttons. Do not hold

for longer that 30 seconds. HomeLink is now in the

train (or learning) mode and can be programmed at

any time beginning with ⬙Programming⬙ - step 2.

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink

button previously trained, follow these steps:

1. Press and hold the desired HomeLink button. DO

NOT release the button.

2. The EVIC will display “CHANNEL X TRANSMIT” for

20 seconds and then change to “CHANNEL X TRAIN-

ING”. Without releasing the HomeLink button, proceed

with ⬙Programming⬙ step 2

For questions or comments, contact HomeLink at:

www.homelink.com or 1-800-355-3515.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 165

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 471 472

Comments to this Manuals

No comments

Chrysler 2007 Aspen User Manual Page 165

Comments to this Manuals

Related products and manuals for Cars Chrysler 2007 Aspen