Chrysler RAM 5500 2013 Installation Guide download pdf (Page 7)

01/22/2010

2011 Chassis Cab

PTO Operation & Installation Guide

OUT

ALL

OUT

ALL

Stationary PTO/Remote PTO Calibrations:

Maximum Engine Torque

The engine torque will be limited to this value when PTO or Remote PTO is Active.

Maximum Vehicle Speed

The maximum vehicle speed allowed before deactivating PTO. Range 1-25 MPH.

Minimum Engine Speed

Defines the lower limit engine speed can be adjusted to when PTO/Remote PTO is

active. The engine speed can be reached by either Ramp down or Bump down.

Maximum Engine Speed

Defines the upper limit engine speed can be adjusted to when PTO/Remote PTO is

active. The engine speed can be reached by either Ramp up or Bump Up.

Engine Speed Ramp Rate

The ERPM/second change rate allowed during a ramp up or ramp down.

Idle Up Set Speed

Initial engine speed when Idle up is activated.

umber of Remote PTO Speed Settings

Total number of engine speed selections available to Remote PTO feature. Range 1-5.

Remote PTO Speed Setting 1, 2, 3, 4 and 5

Individual engine speed settings available to Remote PTO feature.

Electrical Connection to the Vehicle

The vehicle wiring provides an easy access point to connect your PTO. There are two

locations provided for ease of interface 1) is a 8 way connector located on the left side of

the vehicle near the bell housing of the transmission and 2) is a connector located in the

cab of the vehicle. These connectors contain the circuits required to integrate the PTO to

the vehicles electrical system. The following chart is provided to assist in correctly

interfacing the PTO with the vehicle:

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

No comments

Chrysler RAM 5500 2013 Installation Guide Page 7