Chrysler Dodge Charger 2013 Owner's Manual Page 82

  • Download
  • Add to my manuals
  • Print
  • Page
    / 140
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 81
- Electronic Throttle Control (ETC) Indicator Light
This light informs you of a problem with the Electronic Throttle Control (ETC) system.
If a problem is detected, the light will come on while the engine is running. Cycle the
ignition when the vehicle has completely stopped and the shift lever is placed in the PARK
position; the light should turn off.
If the light remains lit with the engine running, your vehicle will usually be drivable;
however, see an authorized service center immediately. If the light is flashing when the
engine is running, immediate service is required and you may experience reduced
performance, an elevated/rough idle or engine stall and your vehicle may require towing.
- Air Bag Warning Light
If the light is not on during starting, stays on, or turns on while driving, have the vehicle
ser viced by an authorized service center immediately.
SERVICE AWD SYSTEM Message
If the SERVICE AWD SYSTEM warning message appears after engine start up, or during
driving, it means the AWD system is not functioning properly. We recommend you do not
operate the vehicle. Have the vehicle serviced immediately.
Sport Shifting
This light will illuminate when Track mode is selected. This mode provides performance
based transmission shifting in either Auto or Manual mode.
Sport Suspension Indicator
The light will illuminate when Sport or Track mode is selected. This mode provides perfor-
mance based tuning with improved handling through an electronic controlled damping
system.
Oil Change Indicator
Message
If an “oil change due” message (shown as Oil Change Due) appears and a single chime
sounds, it is time for your next required oil change.
Resetting The Light After Servicing
Vehicles Equipped With Keyless Enter-N-Go™
Without pressing the brake pedal, push the ENGINE START/STOP button and cycle the
ignition to the ON/RUN position (Do not start the engine.)
Fully depress the accelerator pedal, slowly, three times within 10 seconds.
Without pressing the brake pedal, push the ENGINE START/STOP button once to return
the ignition to the OFF/LOCK position.
Vehicles Not Equipped With Keyless Enter-N-Go™
Turn the ignition switch to the ON/RUN position (Do not start the engine.)
Fully depress the accelerator pedal, slowly, three times within 10 seconds.
Turn the ignition switch to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this procedure.
WHAT TO DO IN EMERGENCIES
80
Page view 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 139 140

Comments to this Manuals

No comments